The servicename could be the same as the mode of operation - REQMOD or RESPMOD, or it could be something custom and vendor specific.Enter the DLP/AV ICAP URL in the following format: On the first ICAP Server Settings pane:.The ICAP Scan Settings page is displayed.To enable and configure the ICAP servers: If two ICAP servers are enabled transfers will be scanned by both servers.
To enable ICAP scanning, first enable ICAPScan package in Transaction Manager and then restart Transaction Manager. Up to two ICAP servers can be configured. The McAfee Web Gateway is supported by SecureTransport ICAP scanning. Both the Symantec anti-virus AVSCAN and AVSCANREQ are supported, though AVSCANREQ is preferred. The SecureTransport administrator can edit the entire DLP/AV ICAP URL in the following format icap://dlpav-address:port/servicename. For information on enabling ICAPScan, refer to Enable a rules package. Prior to configuring ICAP scanning, verify that ICAPScan is enabled. ICAP server scan is executed when a file is going to be (therefore before it is) delivered. SecureTransport allows the administrator to use the ICAP connector to set up a SecureTransport server to scan (with external DLP engine) files when delivering them to the recipient folder. The Internet Content Adaptation Protocol (ICAP) settings allow the administrator to configure ICAP engines to be used as part of the SecureTransport file transfer processes so that data loss prevention (DLP) is achieved and anti-virus (AV) scans are completed.